Written Tomash_Design Read the quoted message
Master - class of Tomas Olga. Imitation of copper surface with embossed on the frame of an antique mirror.
frame of the mirror was in very bad condition, so to return to her original form was almost impossible, therefore, was used decorating reception - an imitation of a copper surface that perfectly hides the error surface and even takes their dignity. Small bumps and holes on Shashel (wood beetle), scratches only to emphasize the dignity of the surface. This technique can be used on all surfaces.
process works:
1. Shpaklyuem large cracks, chips and gouges on the surface sealer for wood furniture.
2. Medium grit sandpaper through the entire surface of the furniture (in this case the frame for a mirror)
3.Obezzhirivaem surface with alcohol or detergent tool.
4. Stained the entire surface of the frame for a mirror acrylic green paint (color dirty - emerald green, not dark) paint is applied flat small brush with short strokes, which are aimed in different directions.
5.Posle of the green paint was dry, just applied to copper Pearl acrylic paint, just need to keep a gap of 2-4 mm, in about equal portions of the surface (4-6 cm)
6.Nanosim picture on the right areas, you can use the stencil (if necessary) Advanced pattern is then applied with a pencil.
7B jar from under the acrylic circuit recruit the same green paint, which stained the first time the surface. Draw picture of the paint through the nozzle by point by point. Since the paint liquid, then the image will be ragged and a little blurry, what we need.
8. Once done to green design has dried, right on it to strike a careful same method of drawing acrylic pearl bronze paint. It is bronze, not copper, so it will be more expressive.
9. Be sure to cover all surface 2 coats of varnish. I use a yacht lak.Vot get the result.
Hosted by Annex I - Photographer
Original entries and comments on LiveInternet.ru
0 comments:
Post a Comment